CRUISE CONTROL SYSTEM > Cruise SET Indicator Light Circuit |
| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Active Test.
Check the cruise control SET indicator light by performing the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Lamp SET | Cruise control SET indicator light | Cruise control SET indicator light ON / OFF | - |
|
| ||||
| OK | ||
| ||