CLEARANCE WARNING ECU > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FRONT DOOR SCUFF PLATE RH |
| 4. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH |
| 5. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH |
![]() |
Disconnect the front door opening trim weatherstrip RH.
| 6. REMOVE INSTRUMENT SIDE PANEL RH |
![]() |
Using a moulding remover, disengage the 4 claws as shown in the illustration.
![]() |
Disengage the 3 guides to remove the instrument side panel RH as shown in the illustration.
| 7. REMOVE FRONT PANEL GARNISH RH |
![]() |
Disengage the 3 clips and 8 guides to remove the front panel garnish RH.
| 8. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD) |
![]() |
Disengage the 4 claws.
Disengage the 2 guides.
Disconnect the connector to remove the No. 2 instrument panel under cover sub-assembly.
| 9. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for LHD) |
![]() |
Remove the bolt <B> and screw <C>.
Open the lower instrument panel door.
![]() |
Remove the 3 screws <C>.
![]() |
Disengage the 2 clips, 4 guides and remove the lower instrument panel sub-assembly as shown in the illustration.
| 10. REMOVE UPPER INSTRUMENT PANEL FINISH PANEL (for RHD) |
![]() |
Disengage the 2 claws and 4 clips to remove the upper instrument panel finish panel as shown in the illustration.
w/ Smart Entry and Start System:
Disconnect the connector.
| 11. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY (for RHD) |
![]() |
Disengage the claw and 2 guides to disconnect the hood lock control lever sub-assembly.
| 12. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY (for RHD) |
![]() |
Remove the 2 bolts <B>.
w/o Driver Side Knee Airbag:
![]() |
Disengage the 5 clips and 3 guides to remove the instrument panel sub-assembly.
w/ Driver Side Knee Airbag:
![]() |
Disengage the 4 claws, 7 clips and 3 guides to remove the instrument panel sub-assembly.
| 13. REMOVE ECU INTEGRATION BOX RH |
for LHD:
Disconnect each connector.
![]() |
Remove the bolt, 2 nuts and ECU integration box RH.
for RHD:
Disconnect each connector.
![]() |
Remove the bolt, 2 nuts and ECU integration box RH.
| 14. REMOVE CLEARANCE WARNING ECU ASSEMBLY |
for LHD:
![]() |
Disengage the 2 claws and remove the clearance warning ECU assembly.
for RHD:
![]() |
Disengage the 2 claws and remove the clearance warning ECU assembly.