Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM

PARKING ASSIST MONITOR SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Chassis / Main Body / Data List.

  5. Read the Data List according to the display on the intelligent tester.


Main Body (Main Body ECU (Multiplex Network Body ECU)) 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Luggage Courtesy SW
Luggage courtesy switch signal/ ON or OFF
ON: Luggage compartment door open
OFF: Luggage compartment door closed
-