AFS (ADAPTIVE FRONT-LIGHTING SYSTEM) > FREEZE FRAME DATA |
| FREEZE FRAME DATA |
Whenever a DTC is detected, the AFS ECU (headlight swivel ECU assembly) stores the current vehicle (sensor) state as freeze frame data.
| CHECK FREEZE FRAME DATA |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / AFS / DTC.
According to the display on the intelligent tester, select the trouble code data display with freeze frame data.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| AFS OFF Switch | AFS OFF switch signal/ON or OFF | ON: AFS off OFF: AFS on | - |
| Traveling Direction | Traveling Direction/Not Fwd or Fwd | Not Fwd: Shift lever in R or N Fwd: Shift lever not in R or N | - |
| Headlight Low Beam State | Low beam headlight state/ON or OFF | ON: Low beam headlights on OFF: Low beam headlights off | - |
| Headlight High Beam State | High beam headlight state/ON or OFF | ON: High beam headlights on OFF: High beam headlights off | - |
| Engine | Engine condition/Run or Stop | Run: Engine running Stop: Engine stopped | - |
| Steering Sens Signal | Steering angle sensor signal value/-384.0 deg to 382.5 deg | Condition can be displayed | - |
| FR Wheel Speed | Front right wheel speed/0.00 to 327.67 km/h (203.61 mph) | Condition can be displayed | - |
| FL Wheel Speed | Front left wheel speed/0.00 to 327.67 km/h (203.61 mph) | Condition can be displayed | - |
| Vehicle Acceleration | Vehicle acceleration/-455.64 to 445.60 m/s2
| Condition can be displayed | - |
| Swivel Motor Slave | Status of the swivel motor slave/Normal or Abnormal | Condition can be displayed | - |
| Swivel Motor Over-Run | Status of the swivel motor over-run/Normal or Abnormal | Condition can be displayed | - |
| Leveling Motor Slave | Status of the leveling motor Slave/Normal or Abnormal | Condition can be displayed | - |
| Leveling Motor Over-Run | Status of the leveling motor over-run/Normal or Abnormal | Condition can be displayed | - |
| +B | IG power supply voltage value/0.00 to 19.75 V | 11 to 14 V | - |
| CLEAR FREEZE FRAME DATA |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Clear the DTCs and freeze frame data (Click here).