Home › Drivetrain ยท U760E AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > ADJUSTMENT

for Preparation Click here



1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Remove the transmission control shaft lever.

    HINT:
    (Click here)



    C135732
  1. Loosen the 2 bolts of the park/neutral position switch assembly.



    C135733E10
  1. Align the protrusions of the park/neutral position switch assembly.
    Text in Illustration 
    *a
    Protrusion



    C135732
  1. Hold the park/neutral position switch assembly in position and tighten the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

    NOTICE:
    After installing the park/neutral position switch assembly, confirm that the 2 protrusions on the switch are aligned.

  1. Install the transmission control shaft lever.

    HINT:
    (Click here)

  1. After the adjustment, perform the switch operation check .