Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND ACCELERATION SENSOR (for Separate Type Yaw Rate Sensor)

YAW RATE AND ACCELERATION SENSOR (for Separate Type Yaw Rate Sensor) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal, Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE CONSOLE BOX ASSEMBLY
(Click here)


4. REMOVE YAW RATE SENSOR


    C247855
  1. Disconnect the connector from the yaw rate sensor.

  1. Remove the 2 nuts and yaw rate sensor.



5. REMOVE NO. 3 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (w/ Smart Entry and Start System)
  1. Disengage the clamp to remove the No. 3 indoor electrical key antenna assembly from the yaw rate sensor bracket.

  1. Disconnect the connector from the No. 3 indoor electrical key antenna assembly.

    NOTICE:
    Be careful when removing the No. 3 indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.



6. REMOVE YAW RATE SENSOR BRACKET


    C247856
  1. Disengage the 2 clamps to separate the wire harnesses.

  1. Remove the 2 bolts and yaw rate sensor bracket.