OUTER REAR VIEW MIRROR > REASSEMBLY |
| 1. INSTALL OUTER MIRROR RETRACTOR (for TMC Made) |
![]() |
Install a new support as shown in the illustration.
![]() |
Pass a new wire harness through a new frame sub-assembly.
![]() |
Connect the connector.
![]() |
Temporarily install the new frame sub-assembly as shown in the illustration.
![]() |
Install the new frame sub-assembly with the 3 screws.
Engage the clamp.
![]() |
Using a T25 "TORX" socket wrench, install the base with 3 new screws.
Engage the clamp.
![]() |
Engage the 5 claws and install a new lower cover.
![]() |
Engage the 5 pins and install a new gasket.
![]() |
Adjust the wire harness so that the marking is at the position shown in the illustration.
| *a | Marking |
![]() |
Wind vinyl tape around the wire harness to secure it.
| *1 | Vinyl Tape |
| Area | Measurement |
| a | 40.0 mm (1.57 in.) |
![]() |
Connect each connector with the adapter.
![]() |
Route the longer wire harness as shown in the illustration.
| *a | Wire harness routing |
![]() |
Wind vinyl tape around the wire harness to secure it.
| *1 | Vinyl Tape |
| Area | Measurement |
| a | 40.0 mm (1.57 in.) |
| 2. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY |
Connect the connector.
Engage the 2 claws to install the side turn signal light assembly.
| 3. INSTALL OUTER MIRROR COVER |
Engage the 7 claws to install the outer mirror cover.
Connect the 2 connectors.
Engage the clamp.
Install the mirror actuator with the 3 screws.
| 4. INSTALL OUTER MIRROR |
Connect the 2 connectors.
![]() |
Engage the 2 guides on the upper part of the outer mirror to the outer mirror.
![]() |
Engage the 2 claws on the lower part of the outer mirror to the outer mirror.