- Cylinder head sub-assembly
- Camshaft (for intake or exhaust camshaft)
- Camshaft timing gear assembly
- Camshaft timing exhaust gear assembly
- Piston or piston ring
- Mass air flow meter sub-assembly
- Fuel injector assembly
- Fuel pump
- Air fuel ratio sensor
- Engine coolant temperature sensor
- Spark plug
- Ignition coil assembly
- Air leaks from intake system
- Gas leaks from exhaust system
| Confirm the following: Perform learning value reset and idle learning when one or more of the following conditions is met.
- A DTC was output before component replacement.
- An air fuel ratio learned value (one of A/F Learn Value Idle #1, A/F Learn Value Low #1, A/F Learn Value Mid1 #1, A/F Learn Value Mid2 #1, and A/F Learn Value High #1) displayed in the Data List was higher than +/- 15% before component replacement.
- Starting failure, rough idle, or engine stalls after component replacement.
| ○
| ○
|