TOYOTA PARKING ASSIST-SENSOR SYSTEM > CUSTOMIZE PARAMETERS |
| 1. CUSTOMIZE TOYOTA PARKING ASSIST-SENSOR SYSTEM |
Customizing with the intelligent tester
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the clearance sonar main switch on.
Turn the intelligent tester on.
Enter the following menus: Body / Clearance Sonar / Utility / Customize.
Select the setting by referring to the table below.
| Display | Default | Content | Setting | Relevant ECU |
| Rr Sensor Onset Range | Wide | Sets the buzzer activation range for the rear center sensors. | Narrow or Wide
| Clearance warning ECU assembly |
| Keep Sense Buzzer | Avail | Sounds the buzzer when the distance between the vehicle and obstacle does not change for more than 3 seconds. | Not Avail or Avail
| Clearance warning ECU assembly |
| Fr & Rr Buzzer Volume | M2 | Changes the buzzer volume setting. | L, M1, M2, M3 or H
| Clearance warning ECU assembly |
| Display | Default | Content | Setting | Relevant ECU |
| Sensor Condition N | Avail | Makes the front sensors available when the shift lever is in N. | Not Avail or Avail
| Clearance warning ECU assembly |
| Reverse Range Front Sensor | F | Changes the operation setting for the front sensors when the shift lever is in R. | F or F Stop
| Clearance warning ECU assembly |
| Non P/R Range Rear Sensor | R Stop | Changes the operation setting for the rear sensors when the shift lever is in any position other than P or R. | R, Rcrn or R Stop
| Clearance warning ECU assembly |