Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



1. CUSTOMIZE METER / GAUGE SYSTEM
  1. Customizing with the intelligent tester

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Customize Setting / Combination Meter / Warning.

    5. Select the setting by referring to the table below.

      NOTICE:
      1. Be sure to record the current value before customizing.

      HINT:
      The following items can be customized using the intelligent tester.


      Warning 
      Tester Display
      Default
      Content
      Setting
      Relevant ECU
      Key Remind Volume
      Large
      Function to change the volume of the key remind warning buzzer
      Large, Medium, Small
      Combination meter assembly
      Key Remind Sound
      Slow
      Function to change the cycle of the key remind warning buzzer
      Fast, Normal, Slow
      Combination meter assembly
      Driver Side Seatbelt Warning Buzzer*1
      ON
      Function to turn on/off the seat belt warning buzzer
      ON or OFF
      Combination meter assembly
      Front Passenger Side Seatbelt Warning Buzzer*1
      ON
      Function to turn on/off the seat belt warning buzzer
      ON or OFF
      Combination meter assembly
      1. *1: This setting is only valid for the buzzer which sounds at 20 km/h (12 mph) or more

  1. Customizing with the combination meter assembly

    HINT:
    1. Press and hold the DISP switch to enter an item.
    2. Briefly pressed the DISP switch to enter an item.


    1. Turn the ignition switch to ON.

    2. Select the following menus: SETTINGS.

    3. Select the setting by referring to the table below.

      NOTICE:
      1. Be sure to record the current value before customizing.

      HINT:
      The following items can be customized for the combination meter assembly.


      Settings 
      Tester Display
      Default
      Content
      Setting
      Relevant ECU
      LANGUAGE
      ENGLISH
      Function to change the multi-information display language
      ENGLISH, FRENCH, SPANISH
      Combination meter assembly
      ECO INDICATOR
      ECO INDICATOR
      Function to change the eco indicator setting
      ON or OFF
      Combination meter assembly

    4. Press and hold the DISP switch.

    5. Return to the item selection screen.