REAR SEAT SIDE AIRBAG ASSEMBLY > DISPOSAL |
| 1. PRECAUTION |
| 2. DISPOSE OF REAR SEAT AIRBAG ASSEMBLY (When Installed in Vehicle) |
![]() |
Check the function of SST .
Refer to Precaution (Click here).
Disconnect the cable from the negative (-) battery terminal.
Remove the rear seat cushion assembly .
Disconnect the connector from the rear seat airbag assembly.
![]() |
Slide the slider to release the lock, and then disconnect the yellow airbag connector as shown in the illustration.
| *a | Slider |
Install SST.
![]() |
Connect the SST connector to the rear seat airbag assembly connector.
![]() |
Move SST at least 10 m (32.8 ft.) away from the rear side window.
| *1 | Battery |
| *a | 10 m (32.8 ft.) or more |
Maintaining sufficient clearance for the SST wire harness in the rear side window, close all doors and windows of the vehicle.
Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.
Deploy the airbag.
Check that no one is inside the vehicle or within a 10 m (32.8 ft.) radius of the vehicle.
Press the SST activation switch to deploy the airbag.
| 3. DISPOSE OF REAR SEAT AIRBAG ASSEMBLY (When Not Installed in Vehicle) |
![]() |
Check the function of SST .
Remove the rear seat airbag assembly (Click here).
![]() |
Using braided wire, tie down the rear seat airbag assembly to an unneeded tire.
| *1 | Stripped Wire Section |
| *a | Wire Diameter |
![]() |
Install the 2 nuts to the rear seat airbag assembly.
![]() |
Wind the wires around the rear seat airbag assembly as shown in the illustration.
![]() |
Position the rear seat airbag assembly inside the tire.
| *a | Width |
| *b | Inner Diameter |
Install SST.
![]() |
Connect the SST connector to the rear seat airbag assembly connector.
Place the tires.
![]() |
Place at least 2 tires under the tire to which the rear seat airbag assembly is tied.
| *1 | Tires (2 or more) |
Place at least 2 tires onto the tire to which the rear seat airbag assembly is tied. The top tire should have a wheel installed.
![]() |
Tie the tires together with the 2 wires.
Install SST.
![]() |
Connect the SST connector.
| *1 | Rear Seat Airbag Assembly |
| *2 | Battery |
| *a | 10 m (32.8 ft.) or more |
Move SST at least 10 m (32.8 ft.) away from the airbag tied down to the tire.
Deploy the airbag.
Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.
Check that no one is within a 10 m (32.8 ft.) radius of the tire to which the rear seat airbag assembly is tied.
Press the SST activation switch to deploy the airbag.
Dispose of the rear seat airbag assembly.
Remove the rear seat airbag assembly from the tire.
Place the rear seat airbag assembly in a plastic bag, tie it tightly, and dispose of it according to local regulations.