Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH

WIPER SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FRONT WASHER OPERATION


    E171721E32
  1. for LHD:
    Text in Illustration 
    *a
    Component with harness connected
    (Windshield Wiper Switch Assembly)

    1. Connect a voltmeter positive (+) lead to terminal I32-3 (+1) and a negative (-) lead to terminal I31-4 (EW).

    2. Turn the ignition switch to ON.



    3. Turn the washer switch on and off, and check the voltage between terminals I32-3 (+1) and I31-4 (EW).

      OK:
      Voltage changes as shown in the illustration.



      E226602E02

      If the result is not as specified, replace the windshield wiper switch assembly.



    E226489E03
  1. for RHD:
    Text in Illustration 
    *a
    Component with harness connected
    (Windshield Wiper Switch Assembly)

    1. Connect a voltmeter positive (+) lead to terminal I32-2 (+1) and a negative (-) lead to terminal I31-7 (EW).

    2. Turn the ignition switch to ON.



    3. Turn the washer switch on and off, and check the voltage between terminals I32-2 (+1) and I31-7 (EW).

      OK:
      Voltage changes as shown in the illustration.



      E226602E01

      If the result is not as specified, replace the windshield wiper switch assembly.