COOLANT > REPLACEMENT |
| 1. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Loosen the cylinder block drain cock plug.
Remove the radiator cap sub-assembly.

| *1 | Radiator Cap Sub-assembly | *2 | Radiator Drain Cock Plug |
| *3 | Cylinder Block Drain Cock Plug | - |
| 2. ADD ENGINE COOLANT |
Tighten the radiator drain cock plug by hand.
Tighten the cylinder block drain cock plug.
Slowly fill the radiator with TOYOTA Super Long Life Coolant (SLLC).
Slowly pour engine coolant into the radiator reserve tank assembly until it reaches the full line.
Squeeze the No. 1 and No. 2 radiator hoses several times by hand, and then check the level of the engine coolant.
If the engine coolant level is low, add engine coolant.
Install the radiator cap sub-assembly and reserve tank cap.
Bleed air from the cooling system.
Warm up the engine until the thermostat opens. While the thermostat is open, circulate the engine coolant for several minutes.
Maintain the engine speed at 2000 to 2500 rpm.
Squeeze the No. 1 and No. 2 radiator hoses several times by hand to bleed air.
Stop the engine and wait until the engine coolant cools down.
Add engine coolant to the full line on the radiator reserve tank assembly.
| 3. INSPECT FOR COOLANT LEAK |
![]() |
Fill the radiator assembly with engine coolant and attach a radiator cap tester.
Warm up the engine.
Using a radiator cap tester, increase the pressure inside the radiator assembly to 118 kPa (1.2 kgf/cm2, 17 psi), and check that the pressure does not drop.
If the pressure drops, check the hoses, radiator assembly and engine water pump assembly for leaks. If no external leaks are found, check the heater core, cylinder block and cylinder head.