CLOCK > REMOVAL |
| 1. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY |
![]() |
Using a moulding remover, pry up on the center instrument cluster finish panel sub-assembly until there is enough of a gap to make it possible to pull on the panel by hand.
![]() |
Pull the center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 7 clips and 2 guides to remove the center instrument cluster finish panel sub-assembly as shown in the illustration.
| 2. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY |
![]() |
Pull the No. 2 instrument panel register assembly in the direction indicated by the arrow to disengage the 4 clips as shown in the illustration.
Disconnect the connector to remove the No. 2 instrument panel register assembly.
| 3. REMOVE CLOCK ASSEMBLY |
![]() |
Remove the 2 screws and clock assembly with No. 2 bezel.
![]() |
Disengage the 6 claws and remove the clock assembly.