INTEGRATION RELAY > ON-VEHICLE INSPECTION |
| 1. INSPECT ENGINE ROOM JUNCTION BLOCK ASSEMBLY (SIGNAL READING CHECK) |
Signal reading check
Turn the ignition switch to ON.
![]() |
Connect the positive (+) terminal of a voltmeter to the engine room junction block assembly and the negative (-) terminal to the body ground.
| *a | Component with harness connected (Engine Room Junction Block Assembly) |
| *b | Diagnosis Terminal |
Using the illustration below as a reference, determine whether any channels are malfunctioning based on the observed signal reading.

| Channel | Connected Electrical Load | |||
| for 2AR-FE | for 2GR-FE | |||
| w/ Rear Fog Light | w/o Rear Fog Light | w/ Rear Fog Light | w/o Rear Fog Light | |
| ch0 | Radiator fan motor | Magnetic clutch | ||
| ch1 | Condenser fan motor | - | ||
| ch2 | Mirror heater | |||
| ch3 | - | |||
| ch4 | - | |||
| ch5 | Rear fog lights | - | Rear fog lights | - |
| ch6 | Front fog lights | |||
| ch7 | Rear window defogger wire | |||
| ch8 | High beam headlight LH | |||
| ch9 | High beam headlight RH | |||
| 2. INSPECT ENGINE ROOM JUNCTION BLOCK ASSEMBLY (RESULTS OF SIGNAL READING CHECK) |
Results of signal reading check
Depending on the signal reading, perform troubleshooting according the table below.
| Output Signal Reading | Repair Method |
| Normal | Continue troubleshooting for each system. |
| The unit is malfunctioning. | Replace the engine room junction block. |
| A malfunction in a channel (ch0 to ch9) |
|
![]() |
If no signal readings are output, perform troubleshooting according to the following troubleshooting procedure.
| Tester Connection | Switch Condition | Specified Condition |
| 1F-15 (IGN) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Component without engine room junction block assembly (Engine Room Relay Block and Junction Block Assembly) |