DOOR CONTROL RECEIVER > INSTALLATION |
| 1. INSTALL DOOR CONTROL RECEIVER |
Install the door control receiver with the bolt.
Connect the connector.
| 2. INSTALL ROOF SIDE INNER GARNISH RH |
| 3. INSTALL REAR SIDE SEATBACK ASSEMBLY RH (for Fold Down Seat Type) |
Place the rear side seatback assembly RH in the cabin.
Engage the hook to install the rear side seatback assembly RH with the bolt.
Connect the rear seat outer belt to the rear seat shoulder belt guide RH.
| 4. INSTALL REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type) |
![]() |
Engage the claw to install a new rear seat cushion lock hook.
| 5. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type) |
Place the rear seat cushion assembly in the cabin.
![]() |
Engage the 2 hooks of the rear seat cushion assembly to the vehicle body as shown in the illustration.
Confirm that the rear seat cushion assembly is firmly installed.
| 6. INSTALL REAR SEAT SIDE GARNISH RH (for Reclining Seat Type) |
| 7. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH |
![]() |
Align the alignment mark (Blue) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip RH.
| *1 | Alignment Mark (Blue) |
| 8. INSTALL REAR DOOR SCUFF PLATE RH (for Reclining Seat Type) |
| 9. INSTALL REAR SEAT CUSHION LOCK HOOK (for Reclining Seat Type) |
![]() |
Engage the claw to install a new rear seat cushion lock hook.
| 10. INSTALL REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type) |
Place the rear seat cushion assembly in the cabin.
w/ Seat Heater System:
Connect the 2 seat heater connectors.
![]() |
Engage the 2 hooks of the rear seat cushion assembly to the vehicle body as shown in the illustration.
Confirm that the rear seat cushion assembly is firmly installed.
| 11. REGISTER DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY ID (w/o Smart Entry and Start System) |