Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL RECEIVER

DOOR CONTROL RECEIVER > REMOVAL

for Preparation Click here



1. REMOVE REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)


    B281558E01
  1. Disengage the hook of the seat cushion from the vehicle body as shown in the illustration.
    Standard Measurement 
    a
    100 mm (3.94 in.) or less

    NOTICE:
    Follow the instructions below carefully as the cushion frame can be deformed easily.


    1. Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.

    2. Repeat the step above for the other hook.

  1. Remove the rear seat cushion assembly.

    NOTICE:
    Be careful not to damage the vehicle body.



2. REMOVE REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type)


    B279203
  1. Disengage the claw and remove the rear seat cushion lock hook.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure for the LH side and RH side.



3. REMOVE REAR SIDE SEATBACK ASSEMBLY RH (for Fold Down Seat Type)
  1. Disconnect the rear seat outer belt from the rear seat shoulder belt guide RH.



    B281556
  1. Remove the bolt.

  1. Disengage the hook and remove the rear side seatback assembly RH.

    NOTICE:
    Be careful not to damage the vehicle body.



4. REMOVE REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type)


    B290774E01
  1. Disengage the hook of the seat cushion from the vehicle body as shown in the illustration.
    Standard Measurement 
    a
    100 mm (3.94 in.) or less

    NOTICE:
    Follow the instructions below carefully as the cushion frame can be deformed easily.


    1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

    2. Repeat the step above for the other hook.

  1. w/ Seat Heater System:

    1. Disconnect the 2 seat heater connectors.

  1. Remove the rear seat cushion assembly.



5. REMOVE REAR SEAT CUSHION LOCK HOOK (for Reclining Seat Type)


    B279203
  1. Disengage the claw and remove the rear seat cushion lock hook.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure as for the LH side.



6. REMOVE REAR DOOR SCUFF PLATE RH (for Reclining Seat Type)

HINT:
Use the same procedure for the RH side and LH side .



7. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
  1. Disconnect the rear door opening trim weatherstrip RH.



8. REMOVE REAR SEAT SIDE GARNISH RH (for Reclining Seat Type)

HINT:
Use the same procedure for the RH side and LH side .



9. REMOVE ROOF SIDE INNER GARNISH RH

HINT:
Use the same procedure for the RH side and LH side .



10. REMOVE DOOR CONTROL RECEIVER


    B279945
  1. Disconnect the connector.

  1. Remove the bolt and door control receiver.