REAR SEAT CUSHION HEATER > INSPECTION |
| 1. INSPECT REAR SEAT CUSHION HEATER (BENCH TYPE REAR SEAT CUSHION COVER) |
Inspect the rear seat cushion heater LH (bench type rear seat cushion cover).
![]() |
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Rear Seat Cushion Heater LH (Bench Type Rear Seat Cushion Cover)) |
| Tester Connection | Condition | Specified Condition |
| A-1 - B-1 | Always | Below 1 Ω |
| A-2 - A-3 | Always | 3.92 to 4.7 Ω |
| A-3 - A-5 | Always | 3.8 to 4.56 Ω |
| A-4 - B-2 | Always | Below 1 Ω |
Inspect the rear seat cushion heater RH (bench type rear seat cushion cover).
![]() |
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Rear Seat Cushion Heater RH (Bench Type Rear Seat Cushion Cover)) |
| Tester Connection | Condition | Specified Condition |
| A-1 - B-1 | Always | Below 1 Ω |
| A-1 - B-5 | Always | 3.92 to 4.7 Ω |
| A-1 - A-2 | Always | 3.8 to 4.56 Ω |
| A-2 - B-1 | Always | 3.8 to 4.56 Ω |