Home › Vehicle Interior › SEAT › REAR SEAT CUSHION HEATER

REAR SEAT CUSHION HEATER > INSTALLATION

for Preparation Click here



1. INSTALL BENCH TYPE REAR SEAT CUSHION COVER (REAR SEAT CUSHION HEATER SUB-ASSEMBLY)
  1. Temporarily install the bench type rear seat cushion cover (rear seat cushion heater sub-assembly) to the bench type rear seat cushion pad.



  1. Using hog ring pliers, install 24 new hog rings.


    B281585

    NOTICE:
    1. Be careful not to damage the cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.



  1. Using hog ring pliers, install the bench type rear seat cushion cover (rear seat cushion heater sub-assembly) to the bench type rear seat cushion pad with 40 new hog rings.


    B281583

    NOTICE:
    1. Be careful not to damage the cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.



2. INSTALL REAR SEAT CUSHION LOCK HOOK


    B280246
  1. Engage the claw to install a new rear seat cushion lock hook.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure as for the LH side.



3. INSTALL REAR SEAT CUSHION ASSEMBLY
  1. Place the rear seat cushion assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. w/ Seat Heater System:

    1. Connect the 2 seat heater connectors.



    B290775
  1. Engage the 2 hooks of the rear seat cushion assembly to the vehicle body as shown in the illustration.

  1. Confirm that the rear seat cushion assembly is firmly installed.

    NOTICE:
    When installing the rear seat cushion assembly, make sure that the seat belt buckles are not under the seat cushion assembly.