Home › Vehicle Interior › SEAT › REAR SEAT CUSHION HEATER

REAR SEAT CUSHION HEATER > REMOVAL

for Preparation Click here



1. REMOVE REAR SEAT CUSHION ASSEMBLY


    B290774E01
  1. Disengage the hook of the seat cushion from the vehicle body as shown in the illustration.
    Standard Measurement 
    a
    100 mm (3.94 in.) or less

    NOTICE:
    Follow the instructions below carefully as the cushion frame can be deformed easily.


    1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

    2. Repeat the step above for the other hook.

  1. w/ Seat Heater System:

    1. Disconnect the 2 seat heater connectors.

  1. Remove the rear seat cushion assembly.



2. REMOVE REAR SEAT CUSHION LOCK HOOK


    B279203
  1. Disengage the claw and remove the rear seat cushion lock hook.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure as for the LH side.



3. REMOVE BENCH TYPE REAR SEAT CUSHION COVER (REAR SEAT CUSHION HEATER SUB-ASSEMBLY)


  1. Remove the 40 hog rings.


    B281582



  1. Remove the 24 hog rings and bench type rear seat cushion cover (rear seat cushion heater sub-assembly) from the bench type rear seat cushion pad.


    B281584