REFRIGERANT LINE > REMOVAL |
| 1. RECOVER REFRIGERANT FROM AIR CONDITIONING SYSTEM |
Turn the A/C switch on.
Operate the air conditioning with a set temperature of 25°C (77°F) and the blower at low for 10 minutes to circulate the refrigerant. This causes most of the compressor oil from the various components of the air conditioning system to collect in the air conditioning compressor.
Turn the ignition switch off.
Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.
| 2. REMOVE PIPING CLAMP (for 1AZ-FE) |
![]() |
While pressing the end of the No. 1 cooler refrigerant suction hose to the end of the suction pipe sub-assembly, use pliers to squeeze together both sides of the piping clamp until it breaks apart.
| *1 | Suction pipe Sub-assembly |
| *2 | No. 1 Cooler Refrigerant Suction Hose |
| *3 | Piping Clamp |
| *a | Press In |
Separate the No. 1 cooler refrigerant suction hose.
Remove the 2 O-rings from the No. 1 cooler refrigerant suction hose.
| 3. REMOVE PIPING CLAMP (for 2AR-FE) |
![]() |
While pressing the end of the suction hose sub-assembly to the end of the suction pipe sub-assembly, use pliers to squeeze together both sides of the piping clamp until it breaks apart.
| *1 | Suction pipe Sub-assembly |
| *2 | Suction Hose Sub-assembly |
| *3 | Piping Clamp |
| *a | Press In |
Separate the suction hose sub-assembly.
Remove the 2 O-rings from the suction hose sub-assembly.
| 4. REMOVE PIPING CLAMP (for 2GR-FE) |
![]() |
While pressing the end of the suction hose sub-assembly to the end of the suction pipe sub-assembly, use pliers to squeeze together both sides of the piping clamp until it breaks apart.
| *1 | Suction pipe Sub-assembly |
| *2 | Suction Hose Sub-assembly |
| *3 | Piping Clamp |
| *a | Press In |
Separate the suction hose sub-assembly.
Remove the 2 O-rings from the suction hose sub-assembly.