Home
›
Drivetrain ยท DRIVE SHAFT / PROPELLER SHAFT
›
FRONT DRIVE SHAFT ASSEMBLY (for 1AZ-FE)
FRONT DRIVE SHAFT ASSEMBLY (for 1AZ-FE) > REMOVAL > Preparation
SST
09520-00031
Rear Axle Shaft Puller
09520-01010
Drive Shaft Remover Attachment
09930-00010
Drive Shaft Nut Chisel
09960-20010
Ball Joint Puller Set
(09961-02010)
Ball Joint Puller
Assembly
(09961-02060)
Spacer B
EQUIPMENT
Torque wrench
-
Protective tape
-
Protective glove
-
LUBRICANT / Front Drive Shaft Assembly (for 1AZ-FE)
Item
Capacity
Outboard joint grease
100 to 120 g (3.5 to 4.2 oz.)
Inboard joint grease
LH Side
150 to 170 g (5.3 to 5.9 oz.)
RH Side
155 to 175 g (5.5 to 6.1 oz.)
LUBRICANT / Front Drive Shaft Assembly (for 2AR-FE)
Item
Capacity
Outboard joint grease
for TMC Made
171 to 181 g (6.0 to 6.3 oz.)
except TMC Made
100 to 120 g (3.5 to 4.2 oz.)
Inboard joint grease
for TMC Made
175 to 185 g (6.2 to 6.5 oz.)
except TMC Made
LH Side
150 to 170 g (5.3 to 5.9 oz.)
RH Side
155 to 175 g (5.5 to 6.1 oz.)
LUBRICANT / Front Drive Shaft Assembly (for 2GR-FE)
Item
Capacity
Outboard joint grease
164 to 184 g (5.8 to 6.4 oz.)
Inboard joint grease
155 to 175 g (5.5 to 6.1 oz.)
RECOMMENDED TOOLS
09012-2C540
Deep Socket Wrench
30mm
-
09042-1C500
Water Pump Pliers
-
09051-1C110
Plastic Hammer
-
09904-00010
Expander Set
-
(09904-00040)
No. 3 Claw
-
09905-00012
Snap Ring No. 1 Expander
-