Home › Drivetrain ยท DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY (for 2AR-FE)

FRONT DRIVE SHAFT ASSEMBLY (for 2AR-FE) > REASSEMBLY > Preparation



SST 
I000009
09240-00020
Wire Gauge Set


I001826
09521-24010
Drive Shaft Boot Clamping Tool


I000712
09527-10011
Rear Axle Shaft Bearing Remover


I000754
09726-40010
Lower Control Shaft Bearing
Replacer



EQUIPMENT
Torque wrench
-
Protective tape
-
Protective glove
-


LUBRICANT (2011/08 - 2012/07) / Front Drive Shaft Assembly (for 2AR-FE)
Item
Capacity
Outboard joint grease
for TMC Made
171 to 181 g (6.0 to 6.3 oz.)
except TMC Made
100 to 120 g (3.5 to 4.2 oz.)
Inboard joint grease
for TMC Made
175 to 185 g (6.2 to 6.5 oz.)
except TMC Made
LH Side
150 to 170 g (5.3 to 5.9 oz.)
RHSide
155 to 175 g (5.5 to 6.1 oz.)

LUBRICANT (2011/08 - 2012/07) / Front Drive Shaft Assembly (for 2GR-FE)
Item
Capacity
Outboard joint grease
164 to 184 g (5.8 to 6.4 oz.)
Inboard joint grease
155 to 175 g (5.5 to 6.1 oz.)


LUBRICANT (2012/07 -        ) / Front Drive Shaft Assembly (for 1AZ-FE)
Item
Capacity
Outboard joint grease
100 to 120 g (3.5 to 4.2 oz.)
Inboard joint grease
LH Side
150 to 170 g (5.3 to 5.9 oz.)
RH Side
155 to 175 g (5.5 to 6.1 oz.)

LUBRICANT (2012/07 -        ) / Front Drive Shaft Assembly (for 2AR-FE)
Item
Capacity
Outboard joint grease
for TMC Made
171 to 181 g (6.0 to 6.3 oz.)
except TMC Made
100 to 120 g (3.5 to 4.2 oz.)
Inboard joint grease
for TMC Made
175 to 185 g (6.2 to 6.5 oz.)
except TMC Made
LH Side
150 to 170 g (5.3 to 5.9 oz.)
RH Side
155 to 175 g (5.5 to 6.1 oz.)

LUBRICANT (2012/07 -        ) / Front Drive Shaft Assembly (for 2GR-FE)
Item
Capacity
Outboard joint grease
164 to 184 g (5.8 to 6.4 oz.)
Inboard joint grease
155 to 175 g (5.5 to 6.1 oz.)


RECOMMENDED TOOLS
I102194
09012-2C540
Deep Socket Wrench
30mm

-
I103614
09042-1C500
Water Pump Pliers


-
I102201
09051-1C110
Plastic Hammer


-
I000112
09904-00010
Expander Set


-
I001066
(09904-00040)
No. 3 Claw


-
I000114
09905-00012
Snap Ring No. 1 Expander


-