REAR FLOOR PAN > ASSEMBLY REPLACEMENT



  1. K102355
    With the body lower back panel removed.

REMOVAL

Symbol meaning
K100014
Remove Weld Points
K100016
Remove Weld Points

K102161E01


INSTALLATION

Symbol meaning
K100019
Plug Weld
K100021
Plug Weld
K100026
Fillet Weld
INSTALLATION POINT
  1. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimension diagram)
  2. Before temporarily installing the new parts, weld the spare wheel clamp bracket, rear floor pan reinforcement and weld bolts with the standard number of welding points.
  3. When welding *1, make a hole on a new part for plug welding and weld the panel with the panel behind completely.
  4. After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
  5. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K102162E01


K102163E01