REAR FLOOR SIDE MEMBER > ASSEMBLY REPLACEMENT



  1. K102358
    With the body lower back panel removed.

REMOVAL

Symbol meaning
K100014
Remove Weld Points
K100016
Remove Weld Points

K102170E01


K102171E01


INSTALLATION

Symbol meaning
K100019
Plug Weld
K100021
Plug Weld
K100031
Assembly Mark
INSTALLATION POINT
  1. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimension diagram)
  2. For positioning of the new parts, align the installation standard holes of the rear floor side rear member and the member.
  3. After welding, apply undercoating to the corresponding parts. (See the painting / coating)
  4. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K102172E01


K102173E01