NAME PLATE > ATTACHMENT POSITION


  1. Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.

    HINT:
    Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.

  2. Wipe off the remaining double-sided tape using a clean cloth or equivalent.

    NOTICE:
    If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.

  3. After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.

    HINT:
    The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.


Text in Illustration 
*1
NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE
*2
NO. 3 LUGGAGE COMPARTMENT DOOR NAME PLATE
*3
Profile of Luggage Compartment Door Panel
-
-

Reference Value 
Area
Measurement
Area
Measurement
*a
51.7 mm (2.04 in.)
*b
223.0 mm (8.78 in.)
*c
52.9 mm (2.08 in.)
*d
47.4 mm (1.87 in.)
*e
140.8 mm (5.54 in.)
*f
48.0 mm (1.89 in.)
*g
47.1 mm (1.85 in.)
*h
165.5 mm (6.52 in.)
*i
47.9 mm (1.89 in.)
*j
47.6 mm (1.87 in.)
*k
142.8 mm (5.62 in.)
*l
48.2 mm (1.90 in.)

K102397E01