ROCKER PANEL > CUT AND JOIN REPLACEMENT SECTIONS


K101300
  1. Weld work for 980 MPa ultra high strength steel
Follow the welding conditions below when welding ultra high strength steel to assure sufficient weld strength. (When repairing this model)
  1. *1: When welding 2 panels together including 980 MPa ultra high strength steel.

    Spot weld
    Pressure
    2940 N (300 kgf, 661 lbf)
    Weld current
    10000 A
    Weld time
    14 Cyc. (0.23 Sec.)
    Plug weld
    Plug diameter
    10 mm (0.39 in.)
    Wire type
    AWS A5.18 ER70S-3
    Shield gas
    Metal active gas
  1. *2: When welding more than 3 panels together including 980 MPa ultra high strength steel. (When plug welding a third panel to 2 panels which are welded under the conditions described above.)

    Plug weld
    Plug diameter
    Same as the standard method (See the introduction)
    Wire type
    AWS A5.18 ER70S-3
    Shield gas
    Metal active gas

NOTICE:
Be sure to use Metal active gas (Ar 80% + CO2 20%) as the shield gas when plug welding. Sufficient weld strength cannot be assured when using 100% CO2 shield gas.


REMOVAL

Symbol meaning
K100014
Remove Weld Points
K100016
Remove Weld Points
K100022
Cut with Disc Sander etc.
K100023
Cut and Join Location
K100024
Cut Location for Supply Parts
REMOVAL POINT
  1. Do not butt weld or heat repair because the heat decreases the strength of areas where ultra high strength steel is used. (See the introduction)

K102136E01


K101302E01


INSTALLATION

Symbol meaning
K100017
Spot Weld
K100019
Plug Weld
K100021
Plug Weld
K100023
Cut and Join Location
K100026
Fillet Weld
K100027
Butt Weld
K100030
Body Sealer
INSTALLATION POINT
  1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
  2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
  3. If the entire supply part is not needed, remove the part of the supply part that is needed.
  4. Before installing a new part, apply body sealer.

    HINT:
    Apply body sealer in an even, continuous bead.

  5. Follow the welding conditions when welding *1 and *2 to assure sufficient weld strength. (See the introduction)
  6. Before temporarily installing the new parts, weld the front body pillar reinforce lower, center body pillar reinforce upper, center body pillar inner and center body pillar reinforce lower with the standard number of welding points.
  7. After welding the front body pillar reinforce lower, center body pillar reinforce upper, center body pillar inner and center body pillar reinforce lower to the vehicle side, install the front body pillar upper outer and rocker panel outer.
  8. After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
  9. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K101303E01


K102137E01


K101305E01


K102138E01


K101389E01