ROCKER REAR PANEL > CUT AND JOIN REPLACEMENT SECTIONS
With the quarter panel removed.
REMOVAL
Symbol meaning
Remove Weld Points
Cut with Disc Sander etc.
REMOVAL POINT
*1 is reused.
INSTALLATION
Symbol meaning
Plug Weld
Cut and Join Location
Butt Weld
INSTALLATION POINT
If the entire supply part is not needed, remove the part of the supply part that is needed.
Before temporarily installing the new parts, weld the center body pillar reinforce lower and rocker reinforce outer with the standard number of welding points.
After welding the center body pillar reinforce lower and rocker reinforce outer to the vehicle side, install the *1.
After welding, apply body sealer to the corresponding parts. (See the painting / coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.