CAN COMMUNICATION SYSTEM > GENERAL



OUTLINE
  1. The Controller Area Network (CAN) uses V bus and sub bus 2.

  2. The CAN V bus and CAN sub bus 2 are HS-CAN buses that operate at 500 kbps.

  3. Each CAN bus has 2 terminating resistors which are necessary for accurate judgment of communication.

  4. The terminating resistors for each bus are located as shown in the following table.

    Speed Communication
    Bus
    Terminating Resistor Location
    High-speed (HS-CAN)
    CAN V Bus
    1. ECM
    2. Combination Meter Assembly
    CAN Sub Bus 2
    1. Network Gateway ECU
    2. ST-Plug

  5. The network gateway ECU has a gateway function and is used to transmit data between the CAN V bus and the CAN sub bus 2.