Home › Brake › BRAKE (FRONT) › FRONT BRAKE

FRONT BRAKE > INSPECTION

for Preparation Click here



1. INSPECT BRAKE CYLINDER AND PISTON
  1. Check the front disc brake cylinder bore and front disc brake piston for rust and scoring. If necessary, replace the disc brake cylinder assembly and/or front disc brake piston.



2. INSPECT PAD LINING THICKNESS


    C238528E01
  1. Using a ruler, measure the pad lining thickness.
    Text in Illustration 
    *1
    Ruler

    Standard thickness:
    12.0 mm (0.472 in.)

    Minimum thickness:
    1.0 mm (0.0394 in.)

    If the pad lining thickness is less than the minimum, replace the front disc brake pads.

    HINT:
    Be sure to check the wear of the front disc when replacing the front disc brake pads.



3. INSPECT FRONT DISC BRAKE PAD SUPPORT PLATE
  1. Make sure that the front disc brake pad support plates have sufficient rebound, no deformation, cracks or wear, and that all rust and dirt are cleaned off.
    If necessary, replace the front disc brake pad support plates.



4. INSPECT DISC THICKNESS


    C239572E01
  1. Using a micrometer, measure the disc thickness.
    Text in Illustration 
    *1
    Micrometer

    Standard thickness:
    28.0 mm (1.10 in.)

    Minimum thickness:
    25.0 mm (0.984 in.)

    If the disc thickness is less than the minimum, replace the front disc.



5. INSPECT DISC RUNOUT
  1. Inspect the front axle hub bearing looseness and front axle hub runout (Click here).



    C239573E01
  1. Using SST to hold the disc, tighten the disc with the 5 nuts.

    SST
    09330-00021  

    Torque:
    103 N*m{ 1049 kgf*cm , 76 ft.*lbf }



    C239574E01
  1. Using a dial indicator, measure the disc runout 10 mm (0.394 in.) away from the outer edge of the front disc.
    Text in Illustration 
    *1
    Dial Indicator

    Maximum disc runout:
    0.05 mm (0.00197 in.)

    NOTICE:
    Keep the magnet of the dial indicator away from the axle hub and speed sensor.

    If the runout exceeds the maximum value, change the installation position of the disc to minimize the runout. If the runout exceeds the maximum even when the installation position is changed, grind the front disc. If the front disc thickness is less than the minimum, replace the front disc.

  1. Remove the 5 nuts and front disc.