Home › Brake › BRAKE (FRONT) › FRONT BRAKE

FRONT BRAKE > REASSEMBLY

for Preparation Click here



1. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG

HINT:
Fully tighten the front disc brake bleeder plug after bleeding.



2. INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP


3. INSTALL PISTON SEAL


    C239542
  1. Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal.
    Text in Illustration 
    V100155
    Lithium Soap Base Glycol Grease

  1. Install the piston seal to the front disc brake cylinder.

    NOTICE:
    Securely install the piston seal to the groove of the front disc brake cylinder.



4. INSTALL CYLINDER BOOT


    C239545E03
  1. Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot and front disc brake piston.
    Text in Illustration 
    *1
    Cylinder Boot
    *2
    Front Disc Brake Piston
    V100155
    Lithium Soap Base Glycol Grease



    C239546
  1. Install the cylinder boot to the front disc brake piston as shown in the illustration.



5. INSTALL FRONT DISC BRAKE PISTON


    C239547E01
  1. Install the cylinder boot to the front disc brake cylinder as shown in the illustration.
    Text in Illustration 
    *1
    Front Disc Brake Piston
    *2
    Cylinder Boot
    *3
    Front Disc Brake Cylinder

    NOTICE:
    1. Securely install the cylinder boot into the groove of the disc brake cylinder and front disc brake piston.
    2. Do not damage the cylinder boot.