FRONT BRAKE > REMOVAL |
| 1. REMOVE FRONT WHEEL |
| 2. DRAIN BRAKE FLUID |
| 3. SEPARATE FRONT FLEXIBLE HOSE |
![]() |
Remove the union bolt and gasket, and separate the front flexible hose from the disc brake cylinder assembly.
| 4. REMOVE DISC BRAKE CYLINDER ASSEMBLY |
![]() |
Hold the front disc brake cylinder slide pin, and remove the 2 bolts and disc brake cylinder assembly.
| *a | Hold |
| *b | Turn |
| 5. REMOVE FRONT DISC BRAKE PAD KIT |
![]() |
Remove the 2 anti-squeal springs from the front disc brake pads.
![]() |
Remove the 2 front disc brake pads with front anti-squeal shim kit from the front disc brake cylinder mounting.
| 6. REMOVE FRONT ANTI-SQUEAL SHIM KIT |
![]() |
Remove the front disc brake anti-squeal shim from each front disc brake pad.
![]() |
Remove the front disc brake pad wear indicator plate from each front disc brake pad.
| 7. REMOVE FRONT DISC BRAKE FITTING KIT |
![]() |
Remove the 2 front No. 1 disc brake pad support plates and 2 front No. 2 disc brake pad support plates from the front disc brake cylinder mounting.
| *1 | Front No. 1 Disc Brake Pad Support Plate |
| *2 | Front No. 2 Disc Brake Pad Support Plate |
| 8. REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN |
![]() |
Remove the front disc brake cylinder slide pin from the front disc brake cylinder mounting.
| 9. REMOVE FRONT NO. 2 DISC BRAKE CYLINDER SLIDE PIN |
![]() |
Remove the front No. 2 disc brake cylinder slide pin from the front disc brake cylinder mounting.
| 10. REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSHING |
![]() |
Using a screwdriver with its tip wrapped with vinyl tape, remove the front disc brake cylinder slide bushing from the front No. 2 disc brake cylinder slide pin.
| *1 | Vinyl Tape |
| 11. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING |
![]() |
Remove the 2 bolts and front disc brake cylinder mounting from the steering knuckle.
| 12. REMOVE FRONT DISC BRAKE BUSHING DUST BOOT |
![]() |
Secure the front disc brake cylinder mounting in a vise.
Using a screwdriver and a plastic hammer, remove the 2 front disc brake bushing dust boots.
| 13. REMOVE FRONT DISC |
![]() |
Put matchmarks on the front disc and the front axle hub.
| *a | Matchmark |
Remove the front disc.