SFI SYSTEM > DIAGNOSIS SYSTEM |
| DESCRIPTION |
![]() |
| NORMAL MODE AND CHECK MODE |
| 2 TRIP DETECTION LOGIC |
| DLC3 (Data Link Connector 3) |
Check the DLC3 (Click here).
| FREEZE FRAME DATA |
| BATTERY VOLTAGE |
| MIL (Malfunction Indicator Lamp) |
The MIL is illuminated when the engine switch is first turned on (IG) (the engine is not running).
The MIL turns off when the engine is started. If the MIL remains illuminated, the diagnosis system has detected a malfunction or abnormality in the system.
| ALL READINESS |
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Clear the DTCs (Click here).
Turn the engine switch off and wait for at least 30 seconds.
Turn the engine switch on (IG) and turn the Techstream on.
Perform the DTC judgment driving pattern to run the DTC judgment.
Enter the following menus: Powertrain / Engine / Utility / All Readiness.
Input the DTCs to be confirmed.
Check the DTC judgment result.
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|