SFI SYSTEM > DTC CHECK / CLEAR |
| Pending DTC | Store condition | Malfunction detected |
| Clear condition | System determined to be normal or DTCs cleared using Techstream or Cable disconnected from negative (-) battery terminal | |
| Current DTC | Store condition | Malfunction detected (2nd trip) |
| Clear condition | No malfunctions in 40 driving cycles or DTCs cleared using Techstream or Cable disconnected from negative (-) battery terminal | |
| Permanent DTC | Store condition | Malfunction detected (2nd trip) |
| Clear condition | Ignition switch turned to ON after normal judgment obtained in 3 consecutive driving cycles or After DTCs cleared using Techstream or cable disconnected from negative (-) battery terminal, normal judgment obtained and universal trip performed (not for misfire and fuel system DTCs) or After DTCs cleared using Techstream or cable disconnected from negative (-) battery terminal, malfunction not detected when universal trip driving performed (misfire and fuel system DTCs) | |
| MIL | ON | Malfunction detected (2nd trip) |
| OFF | Ignition switch turned to ON after normal judgment obtained in 3 consecutive driving cycles or DTCs cleared using Techstream or Cable disconnected from negative (-) battery terminal |


| CHECK DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Check the DTC(s) and freeze frame data, and then write them down.
Check the details of the DTC(s) (Click here).
| CLEAR DTC (Pending and Current DTC) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Clear the DTCs.
| CLEAR DTC (Pending and Current DTC without using Techstream) |
Perform either of the following operations:
Disconnect the cable from the negative (-) battery terminal for more than 1 minute.
Remove the EFI NO. 1 and ETCS fuses from the engine room relay block and junction block assembly located inside the engine compartment for more than 1 minute.
| CLEAR PERMANENT DTC |

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Check if permanent DTCs are stored.
Clear the DTCs.
Perform the respective confirmation driving patterns in order to obtain a normal judgment for the output DTCs.
Perform the universal trip.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Check that the permanent DTCs have been cleared.