DTC P2102 Throttle Actuator Control Motor Circuit Low |
DTC P2103 Throttle Actuator Control Motor Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2102 | Both of the following conditions continue for 2.0 seconds (1 trip detection logic): (a) The throttle actuator drive duty cycle is 80% or higher. (b) The throttle actuator current is less than 0.5 A. |
|
| P2103 | Either of the following conditions is met (1 trip detection logic):
|
|
| Related DTCs | P2102: Electronic throttle actuator control motor current (low current) P2103: Electronic throttle actuator control motor current (high current) |
| Required Sensors/Components (Main) | Throttle actuator (throttle with motor body assembly) |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 2 seconds: P2102 25 times: P2103 (Case 1) 0.6 seconds: P2103 (Case 2) |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever the following DTCs are not stored | None |
| All of the following conditions are met | - |
| Electronic throttle actuator | On |
| Electronic throttle actuator drive duty cycle | 80% or higher |
| Electronic throttle actuator power supply voltage | 8 V or higher |
| Motor current change during latest 0.016 seconds | Less than 0.2 A |
| Both of the following conditions are met | - |
| Electronic throttle actuator | On |
| Either of the following conditions is met | 1 or 2 |
| 1. Electronic throttle actuator power supply voltage | 8 V or higher |
| 2. Electronic throttle actuator power | On |
| Motor current | Less than 0.5 A |
| Hybrid IC diagnosis signal | Fail |
| Hybrid IC high current limiter monitor input | Fail |

| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY (RESISTANCE OF THROTTLE ACTUATOR) |
Inspect the throttle with motor body assembly (Click here).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (THROTTLE WITH MOTOR BODY ASSEMBLY - ECM) |
Disconnect the throttle with motor body assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E16-2 (M+) - E26-30 (M+) | Always | Below 1 Ω |
| E16-1 (M-) - E26-29 (M-) | Always | Below 1 Ω |
| E16-2 (M+) or E26-30 (M+) - Body ground | Always | 10 kΩ or higher |
| E16-1 (M-) or E26-29 (M-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY (VISUALLY CHECK THROTTLE VALVE) |
Check for foreign objects between the throttle valve and the housing.
|
| ||||
| OK | |
| 4.INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY (THROTTLE VALVE) |
Check if the throttle valve opens and closes smoothly.
|
| ||||
| OK | ||
| ||