AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM > DATA LIST / ACTIVE TEST |
| DATA LIST |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / HL Auto Leveling / Data List.
Read the Data List according to the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Headlight Low Beam State | Low beam headlight state/ON or OFF | ON: Low beam headlights on OFF: Low beam headlights off | - |
| +B | IG power supply voltage value/0.00 to 19.75 V | 11 to 14 V | - |
| Height Sens Pw Supply Val | Height control sensor power supply value/0.00 to 5.00 V | Approx. 5 V | - |
| Rr Height Sens Signal Val | Rear height control sensor signal value/0.00 to 5.00 V | Approx. 2.5 V (When vehicle is level) | Value changes according to vehicle height |
| Vehicle Speed | Vehicle speed/0.00 to 327.67 km/h (203.61 mph) | Condition can be displayed | - |
| Rear Height Adjust Valid Flag | Rear height adjustment range/VALID or INVALID | Condition can be displayed | - |
| Init Writing Count | Number of times for initialization/0 to 255 | Condition can be displayed | - |
| Sensor Initialization Hist | Sensor Initialization History/not comp, 10%, 25%, 50%, 75%, 100% or complied | Condition can be displayed | - |
| Number Of Trouble Codes | Number of trouble codes/0 to 255 | Condition can be displayed | - |
| ACTIVE TEST |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / HL Auto Leveling / Active Test.
Perform the Active Test according to the display on the Techstream.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Drive The Leveling Motor UP*1 | Leveling motor upward operation | ON/OFF | ON: Moves up OFF: Stops |
| Drive The Leveling Motor DOWN*1 | Leveling motor downward operation | ON/OFF | ON: Moves down OFF: Stops |