Condition
| Content
|
Open in output side circuit
| - Stops illuminating the headlights.
- Keeps the headlights off until the power is reinstated (by turning the light control switch from off to the head position).
|
Short between output terminals
| - Stops illuminating the headlights.
- Keeps the headlights off until the power is reinstated (by turning the light control switch from off to the head position).
|
Leak between output terminal and ground point
| - Stops illuminating the headlights.
- Keeps the headlights off until the power is reinstated (by turning the light control switch from off to the head position).
|
Excessively low output voltage
| - Stops illuminating the headlights when the output voltage becomes too low (31 +/- 3 V or less).
- Keeps the headlights off until the power is reinstated (by turning the light control switch from off to the head position).
|
Excessively high output voltage
| - Stops illuminating the headlights when the output voltage becomes too high (69 +/- 4 V or more).
- Keeps the headlights off until the power is reinstated (by turning the light control switch from off to the head position).
|
Excessively high input voltage
| - Stops illuminating the headlights when the input voltage becomes too high (20 +/- 3 V or more).
- Illuminates the headlights again when the voltage returns to the operating voltage range (10 to 16 V).
|
Low input voltage
| - Stops illuminating the headlights when the input voltage becomes too low (below 6 V).
- Illuminates the headlights again when the voltage returns to the operating voltage range (10 to 16 V).
|