Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM

AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM > FAIL-SAFE CHART

for Preparation Click here



AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM
  1. The headlight leveling ECU assembly operates in fail-safe mode if an abnormal condition such as those listed below has been detected, and keep the last low beam status.

    Item
    Abnormality Detection Condition
    Return Condition
    Warning Indicator
    Height control sensor power source voltage
    Abnormal height control sensor power source voltage (4.6 V or less, or 6.25 V or more) is detected.
    Abnormal voltage is not detected for 5 seconds consecutively
    Illuminated
    Height control sensor signal voltage
    Abnormal height control sensor signal voltage (0.25 V or less, or 4.75 V or more) is detected.
    High power source voltage
    Abnormal high IG supply voltage (18.5 V or more) is detected.
    Voltage of 17.5 V or less is detected
    Not illuminated
    Low power source voltage
    Abnormal low IG supply voltage (9.0 V or less) is detected.
    Voltage of 9.3 V or more is detected for 0.1 seconds consecutively
    Not illuminated
    Reset while running
    Reset by a temporary loss of power etc. while driving.
    Vehicle is stopped
    Not illuminated