CRUISE CONTROL SYSTEM > SYSTEM DESCRIPTION |
| CRUISE CONTROL SYSTEM |
![]() |
| *1 | Cruise Control Indicator Light (Illuminated in Green or in Amber) |
| *2 | Cruise Control SET Indicator |
| LIMIT CONTROL |
Low speed limit
The lowest possible set speed is approximately 40 km/h (25 mph). The cruise control system cannot be set when the vehicle speed is below the low speed limit. Control of vehicle speed will be automatically canceled but the stored vehicle speed will be retained when the vehicle speed drops below the low speed limit while the cruise control is controlling vehicle speed.
High speed limit
The highest possible set speed is approximately 200 km/h (125 mph). The cruise control system cannot be set when the vehicle speed is over the high speed limit. Also, + (ACCEL)/RES (RESUME) cannot be used to increase the speed beyond the high speed limit.
| OPERATION OF CRUISE CONTROL |
SET CONTROL
The vehicle speed is stored and speed control begins when the cruise control switch is pushed to -/SET while driving with the cruise control system on (while the cruise control indicator light is illuminated in green), and the vehicle speed is within the set speed range (between the low and high speed limits).
- (COAST) CONTROL
When the cruise control system is controlling vehicle speed and the cruise control switch is pushed to -/SET and held in that position, the cruise control system sends a "throttle valve opening angle 0°" demand signal to the ECM. Following this, the vehicle speed is stored and maintained when the cruise control switch is released.
TAP-DOWN CONTROL
When the cruise control system is controlling vehicle speed and the cruise control switch is tapped to the -/SET side (for approximately 0.6 seconds), the stored vehicle speed decreases by approximately 1.6 km/h (1.0 mph) for each time the switch is tapped. When the cruise control switch is tapped to -/SET and the difference between the current and stored vehicle speed is more than 5 km/h (approximately 3 mph), the current vehicle speed is stored and speed control is performed.
ACCELERATION CONTROL
When the cruise control system is controlling vehicle speed and the cruise control switch is pushed to +/RES and held in that position, the cruise control system sends a signal to the ECM to operate the throttle valve motor of the throttle with motor body assembly to open the throttle valve. Following this, the vehicle speed is stored and maintained when the cruise control switch is released.
TAP-UP CONTROL
When the cruise control system is controlling vehicle speed and the cruise control switch is tapped to the +/RES side (for approximately 0.6 seconds), the stored vehicle speed increases by approximately 1.6 km/h (1.0 mph) for each time the switch is tapped. When the cruise control switch is tapped to +/RES and the difference between the current and stored vehicle speed is more than 5 km/h (approximately 3 mph), the stored vehicle speed will not be changed.
RESUME CONTROL
If cruise control system control of vehicle speed was canceled due to any of the manual cancel conditions (other than turning the cruise control system off using the ON-OFF switch), and if the vehicle speed is between the low and high speed limits, the stored vehicle speed from the time of cancelation will be resumed and maintained when the cruise control switch is pushed to +/RES.
SHIFT DOWN CONTROL
When the vehicle is cruising uphill, the transmission may shift down according to AT control. After the ECM judges that uphill cruising has ended based on the throttle valve angle, the transmission will shift up. If the transmission shifts down during acceleration or resume control, it will shift up after acceleration or resume control is completed.
MANUAL CANCEL CONTROL
Performing any of the following cancels the cruise control system control of vehicle speed (the stored vehicle speed in the ECM is maintained).
| AUTO CANCEL (FAIL-SAFE) |