Home › Drivetrain ยท AXLE AND DIFFERENTIAL › STEERING KNUCKLE

STEERING KNUCKLE > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. INSTALL STEERING KNUCKLE


    C167714E03
  1. Using SST and a press, install a new front axle hub bearing to the steering knuckle.

    SST
    09950-60020   (09951-00810)
    09950-70010   (09951-07100)



2. INSTALL FRONT DISC BRAKE DUST COVER
  1. Install the front disc brake dust cover to the steering knuckle with the 4 bolts.

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }



3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY


    C197764E03
  1. Using SST and a press, install the front axle hub sub-assembly to the steering knuckle.

    SST
    09608-32010  
    09950-60010   (09951-00610)
    09950-70010   (09951-07100)



4. INSTALL FRONT AXLE HUB HOLE SNAP RING
  1. Using snap ring pliers, install a new front axle hub hole snap ring.



5. INSTALL FRONT NO. 1 WHEEL BEARING DUST DEFLECTOR
  1. Set a new front No. 1 wheel bearing dust deflector to the steering knuckle while aligning the cutout for the speed sensor in the front No. 1 wheel bearing dust deflector with the hole of the steering knuckle.



    C166274E01
  1. Using SST and a hammer, install the front No. 1 wheel bearing dust deflector.

    SST
    09316-60011   (09316-00011)
    09608-32010  
    09950-60010   (09951-00500, 09952-06010)
    09950-60020   (09951-00810)



    C247220
  1. Apply mineral oil base grease to the areas indicated by the arrows in the illustration on the front drive shaft assembly contact surface of the front axle hub bearing.
    Text in Illustration 
    V100155
    Mineral Oil Base Grease

    HINT:
    Apply 0.1 to 0.3 g (0.00353 to 0.0106 oz.) of mineral oil base grease to each area.



6. INSTALL FRONT LOWER BALL JOINT ASSEMBLY
  1. Secure the front axle assembly in a vise using aluminum plates.

    NOTICE:
    When using a vise, do not overtighten it.

  1. Install the front lower ball joint assembly to the front axle assembly with a new nut.

    Torque:
    123 N*m{ 1254 kgf*cm , 91 ft.*lbf }

    NOTICE:
    Prevent oil from adhering to the threaded and tapered parts.

  1. Install a new cotter pin.

    NOTICE:
    Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.



7. INSTALL FRONT AXLE ASSEMBLY