STEERING KNUCKLE > REMOVAL |
| 1. REMOVE FRONT AXLE ASSEMBLY |
| 2. REMOVE FRONT LOWER BALL JOINT ASSEMBLY |
Secure the front axle assembly in a vise using aluminum plates.
![]() |
Remove the cotter pin and nut.
![]() |
Install SST to the front lower ball joint assembly as shown in the illustration.
![]() |
Using SST, remove the front lower ball joint assembly from the front axle assembly as shown in the illustration.
| *a | Apply grease |
| *b | Place wrench here |
| 3. REMOVE FRONT NO. 1 WHEEL BEARING DUST DEFLECTOR |
![]() |
Using a screwdriver with its tip wrapped with vinyl tape, remove the front No. 1 wheel bearing dust deflector.
| *1 | Vinyl Tape |
| 4. REMOVE FRONT AXLE HUB HOLE SNAP RING |
![]() |
Using snap ring pliers, remove the front axle hub hole snap ring.
| 5. REMOVE FRONT AXLE HUB SUB-ASSEMBLY |
![]() |
Hold the front axle assembly between aluminium plates in a vise.
Using SST, remove the front axle hub sub-assembly.
![]() |
Using SST and a press, remove the bearing inner race (outside) from the front axle hub sub-assembly.
| 6. REMOVE FRONT DISC BRAKE DUST COVER |
![]() |
Remove the 4 bolts and front disc brake dust cover from the steering knuckle.
| 7. REMOVE STEERING KNUCKLE |
![]() |
Place the bearing inner race (outside) on the front axle hub bearing.
| *1 | Steel Plate |
| *2 | V-block |
Using SST, a steel plate, V-blocks and a press, remove the front axle hub bearing from the steering knuckle.