EXHAUST PIPE > REMOVAL |
| 1. REMOVE TAIL EXHAUST PIPE ASSEMBLY LH |
![]() |
Remove the 2 nuts.
Remove the tail exhaust pipe assembly LH from the 2 exhaust pipe supports.
Remove the gasket from the center exhaust pipe assembly.
| 2. REMOVE TAIL EXHAUST PIPE ASSEMBLY |
![]() |
Remove the 2 nuts.
Remove the tail exhaust pipe assembly from the 3 exhaust pipe supports.
Remove the gasket from the center exhaust pipe assembly.
| 3. REMOVE EXHAUST PIPE DAMPER |
![]() |
Remove the 2 bolts and exhaust pipe damper.
| 4. REMOVE CENTER EXHAUST PIPE ASSEMBLY |
![]() |
Remove the 2 bolts and 2 nuts.
Remove the center exhaust pipe assembly from the 2 exhaust pipe supports.
Remove the gasket from the front exhaust pipe assembly.
| 5. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH |
| 6. REMOVE ENGINE UNDER COVER RH |
| 7. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Front Side) |
![]() |
Remove the 2 nuts and No. 1 exhaust pipe support bracket (for Front Side).
| 8. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
![]() |
Disconnect the 2 wire harnesses from the clamp.
Disconnect the 2 heated oxygen sensor connectors.
![]() |
Remove the 2 bolts and 2 nuts.
Remove the front exhaust pipe assembly from the No. 1 exhaust pipe support bracket (for Rear Side).
Remove the 2 gaskets from the front exhaust pipe assembly.
| 9. REMOVE HEATED OXYGEN SENSOR (for Bank 1) |
![]() |
Using SST, remove the heated oxygen sensor from the front exhaust pipe sub-assembly.
| 10. REMOVE HEATED OXYGEN SENSOR (for Bank 2) |
![]() |
Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.