Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › REMOTE ENGINE STARTER SYSTEM

REMOTE ENGINE STARTER SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK REMOTE ENGINE STARTER ECU


  1. Disconnect the I141 remote engine starter ECU connector.


    B219165E04

  2. Measure the resistance and voltage according to the value(s) in the table below.

    HINT:
    Measure the values on the wire harness side with the connector disconnected.


    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    I141-1 (RSIG) - Body ground
    Y - Body ground
    IG power supply
    Engine switch off
    Below 1 V
    I141-1 (RSIG) - Body ground
    Y - Body ground
    IG power supply
    Engine switch on (IG)
    11 to 14 V
    I141-5 (RSLP) - Body ground
    P - Body ground
    Remote engine starter ECU input signal
    Remote engine starter function operating
    Below 1.5 V
    I141-10 (R+B) - Body ground
    W - Body ground
    +B power supply
    Always
    11 to 14 V
    I141-19 (RGN1) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction in the wire harness.

  3. Reconnect the I141 remote engine starter ECU connector.

  4. Measure the voltage according to the value(s) in the table below.

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    I141-3 (BRX) - Body ground
    R - Body ground
    Accessory BERKES SRX signal
    Remote engine starter or remote engine stop functions operating
    Pulse generation
    I141-4 (BTX) - Body ground
    G - Body ground
    Accessory BERKES STX signal
    Remote engine starter or remote engine stop functions operating
    Pulse generation
    I141-16 (RESD) - Body ground
    B - Body ground
    Remote engine starter diagnosis input signal
    Diagnostic mode entered
    Below 1 V
    If the result is not as specified, the remote engine starter may have a malfunction.