Home › Engine / Hybrid System ยท 2GR-FE › ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > INSTALLATION

for Preparation Click here



1. INSTALL V-RIBBED BELT


    A173434E02
  1. Install the V-ribbed belt.
    Text in Illustration 
    *1
    Water Pump
    *2
    Idler
    *3
    Generator
    *4
    Crankshaft
    *5
    Tensioner
    *6
    A/C Compressor



    A205851
  1. Turn the V-ribbed belt tensioner counterclockwise and remove the 5 mm hexagon wrench.

  1. After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.



2. INSTALL FRONT FENDER APRON SEAL RH


3. INSTALL ENGINE UNDER COVER RH


4. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH


5. INSTALL FRONT WHEEL RH

Torque:
103 N*m{ 1049 kgf*cm , 76 ft.*lbf }