SPIRAL CABLE > INSPECTION |
| 1. INSPECT SPIRAL CABLE SUB-ASSEMBLY |
Remove the spiral cable with sensor sub-assembly from the vehicle .
Visually check for defects with the spiral cable sub-assembly.
The defects are as follows:
Check the spiral cable sub-assembly.

| *A | w/ Steering Pad Switch | *B | w/o Steering Pad Switch |
| *a | Component without harness connected (Spiral Cable Sub-assembly) | *b | Color: Orange |
| *c | Color: Black | - | - |
![]() | Interlock | - | - |
Set the spiral cable sub-assembly to the center position .
Measure the resistance between each terminal of the spiral cable sub-assembly according to the table below.
| Tester Connection | Condition | Specified Condition |
| I28-1 (CCS) - z2-3 | Always | 3 Ω or less |
| I28-2 (ECC) - z2-4 | Always | 3 Ω or less |
| I28-2 (ECC) - z3-7 | Always | 3 Ω or less |
| I28-3 (EAU) - z3-8 | Always | 3 Ω or less |
| I28-4 (AU3) - z3-9 | Always | 3 Ω or less |
| I28-5 (AU2) - z3-10 | Always | 3 Ω or less |
| I28-6 (AU1) - z3-11 | Always | 3 Ω or less |
| I28-7 (SDN) - z3-12 | Always | 3 Ω or less |
| I28-9 (HO) - z3-1 | Always | 3 Ω or less |
| I28-10 (+DP) - z3-2 | Always | 3 Ω or less |
| I28-11 (-DP) - z3-3 | Always | 3 Ω or less |
| I28-13 (IL+2) - z3-5 | Always | 3 Ω or less |
| I28-14 (SUP) - z3-6 | Always | 3 Ω or less |
| I27-1 (D+) - z4-2 (D+) | Always | Below 1 Ω |
| I27-2 (D-) - z4-1 (D-) | Always | Below 1 Ω |
| I27-3 (D2-) - z5-1 (D2-) | Always | Below 1 Ω |
| I27-4 (D2+) - z5-2 (D2+) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| I28-1 (CCS) - z2-3 | Always | 3 Ω or less |
| I28-2 (ECC) - z2-4 | Always | 3 Ω or less |
| I28-9 (HO) - z2-2 | Always | 3 Ω or less |
| I27-1 (D+) - z4-2 (D+) | Always | Below 1 Ω |
| I27-2 (D-) - z4-1 (D-) | Always | Below 1 Ω |
| I27-3 (D2-) - z5-1 (D2-) | Always | Below 1 Ω |
| I27-4 (D2+) - z5-2 (D2+) | Always | Below 1 Ω |
After setting the spiral cable sub-assembly to the center position, rotate the spiral cable sub-assembly 2.5 times clockwise, and measure the resistance as shown in the table below. Then rotate the spiral cable sub-assembly 5 times counterclockwise, and measure the resistance as shown in the table below.
| Tester Connection | Condition | Specified Condition |
| I28-1 (CCS) - z2-3 | Always | 3 Ω or less |
| I28-2 (ECC) - z2-4 | Always | 3 Ω or less |
| I28-2 (ECC) - z3-7 | Always | 3 Ω or less |
| I28-3 (EAU) - z3-8 | Always | 3 Ω or less |
| I28-4 (AU3) - z3-9 | Always | 3 Ω or less |
| I28-5 (AU2) - z3-10 | Always | 3 Ω or less |
| I28-6 (AU1) - z3-11 | Always | 3 Ω or less |
| I28-7 (SDN) - z3-12 | Always | 3 Ω or less |
| I28-9 (HO) - z3-1 | Always | 3 Ω or less |
| I28-10 (+DP) - z3-2 | Always | 3 Ω or less |
| I28-11 (-DP) - z3-3 | Always | 3 Ω or less |
| I28-13 (IL+2) - z3-5 | Always | 3 Ω or less |
| I28-14 (SUP) - z3-6 | Always | 3 Ω or less |
| I27-1 (D+) - z4-2 (D+) | Always | Below 1 Ω |
| I27-2 (D-) - z4-1 (D-) | Always | Below 1 Ω |
| I27-3 (D2-) - z5-1 (D2-) | Always | Below 1 Ω |
| I27-4 (D2+) - z5-2 (D2+) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| I28-1 (CCS) - z2-3 | Always | 3 Ω or less |
| I28-2 (ECC) - z2-4 | Always | 3 Ω or less |
| I28-9 (HO) - z2-2 | Always | 3 Ω or less |
| I27-1 (D+) - z4-2 (D+) | Always | Below 1 Ω |
| I27-2 (D-) - z4-1 (D-) | Always | Below 1 Ω |
| I27-3 (D2-) - z5-1 (D2-) | Always | Below 1 Ω |
| I27-4 (D2+) - z5-2 (D2+) | Always | Below 1 Ω |
After setting the spiral cable sub-assembly to the center position, rotate the spiral cable sub-assembly 2.5 times clockwise. Then while rotating the spiral cable sub-assembly 5 times counterclockwise, measure the resistance as shown in the table below.
| Tester Connection | Condition | Specified Condition |
| I28-1 (CCS) - z2-3 | Always | 3 Ω or less |
| I28-2 (ECC) - z2-4 | Always | 3 Ω or less |
| I28-2 (ECC) - z3-7 | Always | 3 Ω or less |
| I28-3 (EAU) - z3-8 | Always | 3 Ω or less |
| I28-4 (AU3) - z3-9 | Always | 3 Ω or less |
| I28-5 (AU2) - z3-10 | Always | 3 Ω or less |
| I28-6 (AU1) - z3-11 | Always | 3 Ω or less |
| I28-7 (SDN) - z3-12 | Always | 3 Ω or less |
| I28-9 (HO) - z3-1 | Always | 3 Ω or less |
| I28-10 (+DP) - z3-2 | Always | 3 Ω or less |
| I28-11 (-DP) - z3-3 | Always | 3 Ω or less |
| I28-13 (IL+2) - z3-5 | Always | 3 Ω or less |
| I28-14 (SUP) - z3-6 | Always | 3 Ω or less |
| I27-1 (D+) - z4-2 (D+) | Always | Below 1 Ω |
| I27-2 (D-) - z4-1 (D-) | Always | Below 1 Ω |
| I27-3 (D2-) - z5-1 (D2-) | Always | Below 1 Ω |
| I27-4 (D2+) - z5-2 (D2+) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| I28-1 (CCS) - z2-3 | Always | 3 Ω or less |
| I28-2 (ECC) - z2-4 | Always | 3 Ω or less |
| I28-9 (HO) - z2-2 | Always | 3 Ω or less |
| I27-1 (D+) - z4-2 (D+) | Always | Below 1 Ω |
| I27-2 (D-) - z4-1 (D-) | Always | Below 1 Ω |
| I27-3 (D2-) - z5-1 (D2-) | Always | Below 1 Ω |
| I27-4 (D2+) - z5-2 (D2+) | Always | Below 1 Ω |