Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY (for Front Passenger Side)

KNEE AIRBAG ASSEMBLY (for Front Passenger Side) > ON-VEHICLE INSPECTION

for Preparation Click here


CAUTION:
Be sure to correctly follow the removal and installation procedures for the lower No. 2 instrument panel airbag assembly.



1. INSPECT LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (for Vehicle not Involved in Collision)
  1. Perform a diagnostic system check.
    for Separate Type Yaw Rate Sensor: (Click here)
    for Built-in Type Yaw Rate Sensor: (Click here)

  1. Visually check for defects with the lower No. 2 instrument panel airbag assembly installed on the vehicle.

    HINT:
    The defects are as follows:
    1. Cuts
    2. Small cracks
    3. Significant discoloration

    OK:
    No defects are found.

    If any of the defects is found, replace the lower No. 2 instrument panel airbag assembly with a new one.



2. INSPECT LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
  1. Perform a diagnostic system check.
    for Separate Type Yaw Rate Sensor: (Click here)
    for Built-in Type Yaw Rate Sensor: (Click here)

  1. Visually check for defects with the lower No. 2 instrument panel airbag assembly removed from the vehicle.

    HINT:
    The defects are as follows:
    1. Cuts
    2. Small cracks
    3. Significant discoloration
    4. Cracks or other damage to the connector
    5. Deformation or cracks on the instrument panel sub-assembly or instrument panel reinforcement

    OK:
    No defects are found.

    If any of the defects is found, replace the lower No. 2 instrument panel airbag assembly, instrument panel sub-assembly or instrument panel reinforcement with a new one.