Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 INSTRUMENT PANEL WIRE


    B278799E01
  1. Connect the 2 airbag connectors of the No. 2 instrument panel wire to the instrument panel passenger airbag assembly.
    Text in Illustration 
    *1
    Airbag Connector
    *2
    Airbag Connector Lock

    NOTICE:
    1. When connecting any airbag connector, take care not to damage the airbag wire harness.
    2. Be sure to only connect the connectors to each corresponding color.

  1. Push in the 2 locks to install the 2 airbag connectors to the instrument panel passenger airbag assembly.

  1. Engage the clamp.



2. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

NOTICE:
If the hooks are not engaged in the correct order, the deployment part of the instrument panel passenger airbag assembly may be damaged.



    B278797
  1. Engage the 3 hooks as shown in the illustration.

  1. Push the instrument panel passenger airbag assembly to engage the 3 hooks.

  1. Install the 2 screws to install the instrument panel passenger airbag assembly.



3. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY


  1. Engage the 5 guides and temporarily install the instrument panel safety pad assembly as shown in the illustration.


    B280299

    NOTICE:
    1. Do not damage the instrument panel safety pad assembly.
    2. Do not allow the wire harnesses to interfere with the surrounding parts.

  1. Install the 2 clips.

  1. Install the 3 bolts <B> and nut <F> or <G>.

  1. Install the 2 passenger airbag bolts <A>.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Engage each clamp.

  1. Connect each connector.



4. CONNECT NO. 2 INSTRUMENT PANEL WIRE
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



    B278793
  1. Connect the connector.

    NOTICE:
    When connecting any airbag connector, take care not to damage the airbag wire harness.



5. INSTALL NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY



6. PERFORM DIAGNOSTIC SYSTEM CHECK
for Separate Type Yaw Rate Sensor: (Click here)
for Built-in Type Yaw Rate Sensor: (Click here)