Home › Engine / Hybrid System · 2AR-FE › FUEL › FUEL INJECTOR

FUEL INJECTOR > INSPECTION

for Preparation Click here



1. INSPECT FUEL INJECTOR ASSEMBLY


    A196006
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    11.6 to 12.4 Ω

    If the result is not as specified, replace the fuel injector assembly.



  1. Inspect the injector injection.

    CAUTION:
    Keep the injector away from sparks during the test.




      A264971E01
    1. Connect SST (fuel tube connector) to SST (hose) with SST (hose band), and then connect them to the fuel pipe (vehicle side).

      SST
      09268-31014   (09268-41500, 09268-41700, 95336-08070)
      Text in Illustration 
      *1
      SST
      (Hose)
      *2
      SST
      (Hose Band)
      *3
      SST
      (Fuel Tube Connector)
      *4
      Fuel Pipe (Vehicle Side)



    2. A264972E01
    3. Install a new O-ring to the fuel injector.

      SST
      09268-31014   (09268-41110, 09268-41300, 09268-41700, 95336-08070)
      Text in Illustration 
      *1
      SST
      (Hose)
      *2
      SST
      (Hose Band)
      *3
      SST
      (Adapter)
      *4
      O-ring
      *5
      SST
      (Clamp)
      *6
      Vinyl Tube

    4. Connect SST (adapter and hose) to the injector, and hold the injector and union with SST (clamp).



    5. A264974E01
    6. Tie the clamp and adapter together with a tie band as shown in the illustration.

      SST
      09268-31014   (09268-41110, 09268-41300, 09268-41800)
      Text in Illustration 
      *1
      SST
      (Tie Band)
      *2
      SST
      (Adapter)
      *3
      SST
      (Clamp)

    7. Install a vinyl tube onto the injector.

      CAUTION:
      Install a suitable vinyl tube onto the injector to contain any gasoline spray.

    8. Put the injector into the graduated cylinder.

    9. Operate the fuel pump.



    10. A075915E20
    11. Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.
      Text in Illustration 
      *1
      SST
      (Wire)
      *a
      Connect

      SST
      09842-30080  

      NOTICE:
      Always switch the voltage on and off at the battery side, not the injector side.

      Standard Injection Volume:
      Tester Connection
      Condition
      Specified Condition
      Positive terminal - Ground terminal
      Per 15 seconds
      87 to 105 cc (5.3 to 6.4 cu.in.)

      Difference between each injector:
      18 cc (1.1 cu.in.) or less

      If the result is not as specified, replace the fuel injector assembly.

  1. Check for fuel drop.

    1. In the condition above, disconnect the tester probes of SST (wire) from the battery and check for fuel drop from the injector.

      Standard fuel drop:
      1 drop or less per 20 minutes

      If fuel drop is not as specified, replace the fuel injector assembly.