AUTOMATIC TRANSAXLE SYSTEM > INITIALIZATION |
| RESET TRANSAXLE COMPENSATION CODE |
Move the shift lever to N or P.
Turn the engine switch off.
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / ECT / Utility / A/T Code Reset.
Press "Next" again to proceed.
Press "Exit".
| PERFORM ROAD TEST TO ALLOW TCM TO LEARN |
Warm up the engine.
Turn the engine switch off.
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / ECT / Data List / Throttle Position from EFI.
From a standstill, achieve highest possible speed with the accelerator pedal opened 15% or less. Keep the accelerator pedal angle steady while driving the vehicle.
Repeat the previous step until shift shock no longer occurs.
From a standstill, achieve highest possible speed with the accelerator pedal opened 25% to 35%. Keep the accelerator pedal angle steady while driving the vehicle.
Repeat the previous step until shift shock no longer occurs.
| RESET MEMORY |
Reset procedure is as follows.
Turn the engine switch off.
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Enter the following menus: "Powertrain / ECT / Utility / Reset Memory". Then, press "Next".