DTC P0711 Transmission Fluid Temperature Sensor "A" Performance |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0711 | One of the following conditions (A), (B) or (C) is met: (A) (a), (b) and (c) are detected: (2-trip detection logic)
| ATF temperature sensor |
| Related DTCs | P0711: ATF temperature sensor |
| Required sensors/Components | ATF temperature sensor (TFT sensor) |
| Frequency of operation | Continuous |
| Duration | Condition A, B, C and D: 3 sec. Condition E: Continuous |
| MIL operation | 2 driving cycles |
| Sequence of operation | None |
| The monitor will run whenever this DTC is not present. (Not circuit malfunction) | P0712, P0713 (ATF temperature sensor circuit (TFT sensor)) P0115, P0117, P0118 (ECT sensor circuit) P0112, P0113 (IAT sensor circuit) P0715, P0717 (Turbine speed sensor circuit) P0791, P0793 (Intermediate shaft speed sensor circuit) P0748 (Shift solenoid valve SL1 circuit) P0778 (Shift solenoid valve SL2 circuit) P0798 (Shift solenoid valve SL3 circuit) P2810 (Shift solenoid valve SL4 circuit) P0327, P0328, (KCS sensor circuit) P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P060A, P060B, P060D, P060E, P0657, P1607, P2102, P2103, P2111, P2112, P2118, P2119, P2135 ((ETCS) Electronic throttle control system) U0100 (CAN communication system) P2610 (Soak timer circuit) |
| TFT (Transmission fluid temperature) sensor circuit | No circuit malfunction |
| ECT (Engine coolant temperature) sensor circuit | No circuit malfunction |
| IAT (Intake air temperature) sensor circuit | No circuit malfunction |
| Turbine speed sensor circuit | No circuit malfunction |
| Intermediate shaft speed sensor | No circuit malfunction |
| Shift solenoid valve SL1 circuit | No circuit malfunction |
| Shift solenoid valve SL2 circuit | No circuit malfunction |
| Shift solenoid valve SL3 circuit | No circuit malfunction |
| Shift solenoid valve SL4 circuit | No circuit malfunction |
| (KCS) Knock control sensor circuit | No circuit malfunction |
| Soak timer circuit | No circuit malfunction |
| (ETCS) Electronic throttle control system | Not system down |
| CAN communication system | Not system down |
| Engine | Starting |
| Time after engine start | 12 sec. or more |
| ECT (Engine coolant temperature) | -15°C (5°F) or more |
| Time after engine start except for continuing shift position "N" or "P" *2 | 10 min. or more |
| Driving distance after engine start *3 | 5 km (3.1 miles) or more |
| IAT *4 | 15°C (59°F) or more |
| ECT (12 sec. after engine start) | 15°C (59°F) or more |
| Soak time | 5 hours or more |
| Accumulated driving time *1 | 100 sec. or more |
| Time after engine start except for continuing shift position "N" or "P" *2 | 18 min. and 20 sec. or more |
| Driving distance after engine start *3 | 8 km (5 miles) or more |
| IAT *4 | -10°C (14°F) or more |
| ECT (12 sec. after engine start) | -10°C (14°F) or more |
| Accumulated driving time *1 | 185 sec. or more |
| Time after engine start except for continuing shift position "N" or "P" *2 | 30 min. or more |
| Driving distance after engine start *3 | 15 km (9.3 miles) or more |
| IAT *4 | -15°C (5°F) or more |
| ECT (12 sec. after engine start) | -15°C (5°F) or more |
| Accumulated driving time *1 | 400 sec. or more |
| Time after engine start except for continuing shift position "N" or "P" *2 | 40 min. or more |
| Driving distance after engine start *3 | 20 km (12.4 miles) or more |
| Accumulated driving time *1 | 550 sec. or more |
| Time after ECT reaches 60°C (140°F) | 10 sec. or more |
| TFT (12 sec. after engine start) | 110°C (230°F) or more |
| ECT (12 sec. after engine start) | 35°C (95°F) or less |
| Engine speed - Turbine speed | 10 rpm or more |
| Output speed | 400 rpm or more |
| Throttle valve opening angle | 3% or more |
| Shift position | Not "N" or "P" |
| Engine | Starting |
| However, accumulated driving time is cleared | |
| When following condition met | |
| Duration time from shift position "N" or "P" | 600 sec. or more |
| Shift position "N" or "P" is cleared | |
| When following condition met | |
| Duration time from shift position "N" or "P" | 600 sec. or more |
| Duration time from shift position "N" or "P" | 600 sec. or more |
| IAT (12 sec. after engine start) | |
| When following condition met | |
| IAT at duration time from shift position "N" or "P" | 600 sec. or more |
| TFT | Less than 20°C (68°F) (THO = -10°C (14°F) at engine start) (Conditions vary with THO at engine) |
| TFT | 110°C (230°F) or more |
| TFT | Atmospheric temperature - approx. 130°C (266°F) |

| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| A/T Oil Temperature 1 | ATF temperature sensor value/ Min.: -40°C (-40°F) Max.: 215°C (419°F) |
| If value is -40°C (-40°F) or 150°C (302°F), ATF temperature sensor circuit is open or short circuited |
| Temperature Displayed | Malfunction |
| -40°C (-40°F) | Open circuit |
| 150°C (302°F) or more | Short circuit |
| 1.CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0711) |
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / ECT / Trouble Codes.
Read the DTCs using the Techstream.
| Display (DTC Output) | Proceed to |
| Only P0711 is output | A |
| P0711 and other DTC | B |
|
| ||||
| A | |
| 2.CHECK TRANSMISSION FLUID LEVEL |
Check the transmission fluid level (Click here).
|
| ||||
| OK | ||
| ||